Install Garbaruk RD cage on Sram 10-speed rear derailleur

Following Garbaruk guidelines will guarantee seamless drivetrain operation with your new components

FOLLOW THE STEPS BELOW TO INSTALL GARBARUK RD CAGE ON SRAM 10-SPEED REAR MECH

TABLE OF CONTENTS

• Tools you will need
• STEP 1: Undo the bolts holding derailleur pulleys in place
• STEP 2: Unmount the main cage part
• STEP 3: Prepare the Garbaruk cage for assembly
• STEP 4: Install Garbaruk cage
• STEP 5: Fix Garbaruk cage in place
• STEP 6: Install derailleur pulleys back in place
• Garbaruk RD cage installation is finished

Tools you will need

In order to install Garbaruk RD cage seamlessly, you will need the following tools:

• 3mm Allen key
• 2.5mm Allen key
• heat gun (required for removing standard Carbon cage, if your rear mech comes with one)

STEP 1: Undo the bolts holding derailleur pulleys in place

STEP 2: Unmount the main cage part

Use heat gun if you're removing the SRAM carbon cage

STEP 3: Prepare the Garbaruk cage for assembly

Please take into account the difference between different cage models for regular SRAM rear mechs and SRAM derailleurs with carbon cage

Place the plastic cap according to the scheme belowprzęgła przerzutki do odpowiedniego otworu w korpusie sprzęgła

STEP 4: Install Garbaruk cage

Insert the outer end of derailleur clutch spring into the appropriate hole on the plastic cap and compress the spring (displayed on the second picture below)

Tighten the bolt fixing the main cage in place by 2-3 turns

STEP 5: Fix Garbaruk cage in place

By rotating the cage with fixing bolt in place in counter-clockwise direction, you will tighten the derailleur clutch spring and secure the cage in place

Tighten the fixing bolt to 8 Nm torque (recommended maximum torque value)

STEP 6: Install derailleur pulleys back in place

Garbaruk RD cage installation is finished